Using the ADS1298RECG-FE Software
33
SBAU181B – March 2011 – Revised Janurary 2016
Copyright © 2011–2016, Texas Instruments Incorporated
ADS1298R
3.6
Save Tab
The
Save
tab provides the user the ability to save the collected data for a record of the evaluation or
further analysis. Reference the previous sections for the list of the analysis data available for each
analysis.
The
Analysis to Save
group allows the user to save the different analysis calculations that were performed
on the data.
•
Scope Analysis
saves the scope analysis data available from the scope analysis pop-up window
•
FFT Analysis
saves the FFT analysis data available from the FFT analysis pop-up window.
•
Histogram Analysis
saves the histogram analysis data available from the histogram analysis pop-up
window.
•
Register Settings
saves the current settings from the register map and can be useful to obtain the
register values for your specific device configuration. Saving the register map in this format is not be
confused with saving your register settings for reloading into the software at another time (see
Each item will be saved if the corresponding checkbox is checked.
The
Data to Save
group allows the user to save the various data sets collected from the ADS1298R. The
CH x
controls allow the user to specify which channels will be saved for each of the data selections made.
•
Data - Codes
selects the raw data (in codes format) to be saved to a file.
•
Data - Volts selects the raw data (converted to voltage) to be saved to a file.
•
FFT Data selects the calculated FFT data to be saved to a file. Note: This is not raw data; it is the
frequency bin and magnitude data that was calculated by the UI.
•
Histogram Data selected the calculated Histogram data to be saved to a file. Note: This is not raw
data; it is the code bin and number of occurrences data that was calculated by the UI.
The User Comments/Notes group allows the user to indicate a
Record Number
and
User Comments
that are saved with each file. This data permits the user to distinguish different data sets from one
another.
The
Directory to Save Files
is the directory where all the saved files will be placed. The user can select a
directory by pressing the folder button (located to the right of the control). Each data file that is saved is
automatically named to prevent overwriting of files.
The
Save To File
button saves all the data files that were selected using the check boxes to the selected
directory.
