TEXA 10TD088A0, Manual

Page: 58 / 185

9 SOLUTIONS TO PROBLEMS
For any technical problem non-solvable following the instructions below,
please contact your Distributor/Dealer.
PROBLEM PROBABLE CAUSE POSSIBLE SOLUTION
With the tool connected
to PC, the indication of
battery in charge does
not pop up.
The PC is not switched
on or is in stand-by.
Turn on the PC.
The USB cable is not
connected properly or is
defective.
Check connection and/
or replace the cable.
The measurement is
clearly wrong.
The distance between
microphone and belt is
excessive.
Point the microphone
towards the belt while
keeping it at the
prescribed distance.
The point of the belt
where the measurement
is done does not
correspond to the one
indicated by the
manufacturer. Place the microphone in
the point indicated by
the vehicle
manufacturer, while
keeping it at the
prescribed distance.
The environments
where the measurement
is done is too noisy.
Minimize the
background noise of the
environment as much as
possible.
The tool is damaged,
possible damages to the
microphone.
Contact the Distributor/
Dealer.
The tool is switched on
and charged, but does
not measure.
The microphone is not
pointed towards the belt.
Point the microphone
towards the belt while
keeping it at the
prescribed distance.
58