14
• Cinebar Ultima
Setup/Wall Mounting
NOTICE
If the device is subjected
to warm temperatures after
being cold (e.g. after trans-
port), condensation may occur
inside of it.
–
In this case, wait approx.
2 hours before you connect
and activate it.
The isolation pads can
produce discolouration on
sensitive surfaces.
–
On parquet, varnished wood
and similar surfaces, you
should stick felt gliders to the
rubber feet of the device or
put a blanket under it. This
will prevent discolouration of
the floor over the long term.
Setup location
The space in front of or under the TV
set is an ideal location.
Location tips
• Select a stable, level base.
In case of wall mounting, follow the
instructions in the next chapter.
• The Cinebar Ultima uses side-firing
speakers. For the best sound-
quality ensure the speakers are
able to play freely. Do not locate
the device in a side-closed cabin or
closet.
• Make sure that the environment is
clean and free from dust.
• Select a location away from heat
sources and direct sunlight.
• Do not place any heavy objects on
the cables or the device.
Protective grids
You can protect the speakers with the
protective grids
(2)
and
(3)
.
Especially high frequencies will sound
clearer without the protective grids.
HDMI
(3)
(2)
–
The grids have magnetic pins that
click onto the corresponding jacks
on the speaker.
–
You can take the protective grids
off of the speakers by carefully
reaching behind the protective
grids and slowly pulling them off to
the front.
NOTICE
Risk of damage!
–
Make sure that you do not
touch the highly sensitive
diaphragms.
