5 First steps
38
Bus address
The bus address of each component connected to the Testo data
bus must be unambiguous. The bus address of the connected
component can be changed, if necessary.
1.
Bus Address
→
[Edit]
.
2.
Setting a new bus address:
[ ]
,
[ ]
,
[
◄
]
,
[
►
]
.
3.
Confirm the entry:
[OK]
.
Bus rate
The relevant data rate must be selected depending on the number
of connected components in a system.
• Control unit with one measuring box:
500 kbit/s
• All other systems
: 50 kbit/s
> Select
bus rate 500 kbit/s
or
50 kbit/s
:
[ ]
,
[ ]
,
→
[Edit]
→
[ ]
or
[ESC]
.
If several meas. boxes are connected with the Control Unit,
only the measurement data from one meas. box can be
displayed at a time, or only one meas. box can be activated
respectively. This is accomplished by selecting the meas.
If several meas. boxes are connected to a notebook/PC,
the meas. boxers can be activated and opened parallel to
each other, e.g. to display measuring channels of different
meas. boxes parallel to one another.
If a notebook/PC or data bus controller (0554 0588) has
several connected and enabled measuring boxes, the
minimum measuring rate changes, depending on the
number of measuring boxes, as follows:
Measuring
boxes
Minimum
measuring rate
1 to 2
1 s
3 to 4
2 s
5 to 8
3 s
9 to 16
5 s
> Connect the Data bus cable to the Data bus interfaces.
Please observe the following points when setting up a connection
via Data bus cable:
• Use only Testo databis cables
Summary of Contents for 350 Maritime V2
Page 1: ...testo 350 Flue gas analyzer Instruction manual...
Page 2: ...2...
Page 106: ...0970 3511 en 05_GB...
