Vibrating Table
2.0231 / 2.0268 / 2.0269
2.0131 / 2.0233 / 2.0234
2.0271
6
If the operating safety of the device is impaired by defects or damage, the device should
be taken out of operation immediately and should only be used again after all of the
sources of danger have been dealt with.
Check to see whether the specification that is given on the identification plate corresponds
with your mains voltage. Connect only to alternating current.
Use the device only for the applications that are described here. Improper usage will lead
to the loss of guarantee cover.
If the device or the power supply line is damaged, then remove the power plug immedi-
ately.
The unit has been built with the latest technology and according to the approved technical
regulations. However, when it is used, it could lead to dangers for life and limb for the
operator or for a third party, or to impairments or damage to machine technical compo-
nents or to other material assets.
Manipulations and modification to the machine (electrical and mechanical alterations,
etc.) that have not been authorised with the written agreement of the manufacturer shall
be considered to be forbidden and the manufacturer shall accept no claims for damages.
The machine must be positioned at a location that is fire proof and explosion proof.
1.5.3 Information about the CE symbol
TESTING Bluhm & Feuerherdt GmbH testing devices carry the CE symbol.
The CE marking confirms that the product conforms with the EC Directives that must be
taken into consideration for the product and also that the product is in compliance with
the “essential requirements” that are defined therein, and the defined general relevant
level of protection. The conformity-assessment procedure has in each case been carried
out in accordance with the applicable EC Directives. Decisive here is Council Decision on
the modules to be used in the technical harmonisation directives for the various phases
of the conformity-assessment procedure and the regulations for the mounting and usage
of the CE mark.
To confirm the conformity with EU Directive 2014/30/EC on Electromagnetic Compatibility
(EMC), our products are tested in accordance with the EMC requirements for emitted
interference and interference immunity for electrical measurement, control, regulation and
laboratory devices.
Compliance with the safety requirements in residential areas, commercial and light indus-
trial areas as well as small businesses (residential areas and buildings that are connected
directly to the public low voltage power supply network) as well as the safety requirements
in the industrial area, is fulfilled. Our strict regulations regarding performance level and
the considerable efforts made in development and inspections underline the efforts that
we make to guarantee the high level of quality of our products, even under difficult electro-
magnetic conditions.