Tesla RW091M, User Manual, Page: 6 / 104

6
ENG
Placement
Start to use
The arrangement of bottle
• Before using the cooler, remove all packaging materials including bottom cushions and foam pads and
tapes inside the cooler, tear off the protective film on the door and the cooler body.
• Avoid direct sunlight and heat sources such as stove, heating radiator, etc.
• The cooler is placed in a well-ventilated indoor place; the ground shall be flat, and sturdy (rotate left or
right to adjust the wheel for levelling if unstable).
• The top space of the cooler shall be greater than 30cm,and the distances from both sides and backside
shall be more than 10cm to facilitate heat dissipation.
• After transportation, please let the wine cooler stay for more than 2 hours before turning on the power,
otherwise it will lead to a decrease in cooling capacity or a damage to the wine cooler. The cooler shall
stay for half an hour before connecting power when it is firstly started. Clean up the inner chamber
before put into use for first time .
• Please pull out plug in case of power failure or cleaning. Do not connect the wine cooler to power
supply within five minutes to prevent damages to the compressor due to successive starts.
• In the process of compressor work, water droplets or frost will be formed on the back wall of the
refrigerated compartment, which is a normal phenomenon. After a period of time, the frost will melt
into water and flow into the water tray to evaporate away.
• Do not connect cooler to electronic energy saving plug and converter that can convert DC into AC
(E.g.: solar energy system, ship grid).
• Do not let bottle touch the back side of wine cooler in order to maintain good air circulation in the
cooler.
• The bottle number here may be different from bottles in different shape and size.
• The capacity for bottle storage in the wine cabinet is based on the following marked bottle size.
Oversized bottle may have impact on the number of bottle storage in the wine cabinet.
• This cooler needs to be installed independently
and cannot be used as a built-in. Otherwise,
it will cause problems such as failure to install
into the cabinet, the performance and life of
the product are reduced. And the manufacturer
does not provide basic product warranty.
The picture above is only for reference. The actual configuration will depend on the physical product or
statement by the distributor.