If you replace a wheel, the TPMS (Tire Pressure
Monitoring System) sensors need to be reset to ensure
they provide accurate warnings when tires are under- or
over-inflated (see
Automatic Reset of TPMS Sensors on
).
For the specification of the original wheels and tires
installed on Model X, see
.
WARNING:
For your safety, use only tires and
wheels that match the original specification. Tires
that do not match the original specification can
affect the operation of the TPMS.
WARNING:
Never exceed the speed rating of your
vehicle's tires. The speed rating is shown on the
sidewall of your tires (see
).
Asymmetric Tires
Model X tires are asymmetric and must be mounted on
the wheel with the correct sidewall facing outward. The
sidewall of the tire is marked with the word OUTSIDE.
When new tires are installed, make sure that the tires are
correctly mounted on the wheels.
WARNING:
Road holding is seriously impaired if
the tires are incorrectly installed on the wheels.
Removing and Installing Aero Covers
If your Model X is equipped with aero covers, you must
remove them to access the lug nuts.
To remove an aero cover:
1. Grasp the aero cover firmly with both hands.
2. Pull the aero cover toward you to release the
retaining clips.
To install an aero cover:
1. Align the aero cover into position so that the notch at
the base of the Tesla "T" is aligned with the tire's
valve stem.
2. Push firmly around the perimeter of the aero cover
until it fully snaps into place.
CAUTION:
To prevent the aero cover from
falling off, ensure that it is fully secured before
driving.
Removing and Installing Lug Nut Covers
If your Model X is equipped with lug nut covers, you
must remove them to access the lug nuts.
To remove a lug nut cover:
1. Insert the curved part of the lug nut cover tool, if
equipped (located in the glovebox in some vehicles,
or you can use a small allen wrench) into the hole at
the base of the Tesla "T".
NOTE:
The lug nut cover tool can also be purchased
at an auto parts store or through online retailers.
2. Maneuver the lug nut cover tool so that it is fully
inserted into the hole in the lug nut cover.
3. Twist the lug nut cover tool so that the curved part is
touching the middle of the lug nut cover.
4. Firmly pull the lug nut tool away from the wheel until
the lug nut cover is released.
To install the lug nut cover:
1. Align the lug nut cover into position.
2. Push firmly on the lug nut cover until it fully snaps
into place.
Tire Care and Maintenance
193
Maintenance
