Installation
7
Installation
Installing the Home Connector
Note:
Dimensions above are shown in
inches. 1 inch = 2.54 cm.
1. Locate the wall mounting position:
•
The bottom of the Home Connector
must be positioned 38 inches (1 meter)
above the ground.
•
The mounting holes are spaced 16”
(40.6 cm) apart to accommodate wall
studs.
In the absence of solid structural
framing, you must provide an
adequate mounting surface.
2. Attach the Home Connector to the wall
studs using four 1/4” x 2 1/2” (M6) lag
screws. The length of the screws must
be adequate to securely anchor the
Home Connector.
If mounting on a concrete wall, use a
multi-set (or equivalent).
3. Remove the applicable power entry
knock-out from the Home Connector,
push the power leads through the hole,
then connect the power conduit to the
hole.
Continue the installation by following the
electrical connection procedure, provided
next.
Home Connector Users Manual.book Page 7 Monday, April 26, 2010 12:38 PM
