TF13
EN
3
ASSEMBLY
For ease of assembly, lay the Fan down so that the front
1.
grill and control panel are facing up. Identify the two base
sections A and B.
Remove the four screws attached to the support pillars in
2.
Section B and keep them safe
Thread the Power Cord through the centre of the support
3.
base section A.
Align the two Base sections by interlocking the guides on
4.
Base A with the support pillars on Base B. Push them firmly
together. (refer to Fig 1 below)
Fig.1
Attach the four screws into the four holes in the pillars at
5.
the bottom of the base.
Note the position of the power cord. (Figure 2)
Fig.2
Power Cord
Base
Section
A
Support Pillars
Base
Section B
Assembled
Base
Power
Cord
Screws
Remove the four screws in the base of the fan column and
6.
save them
Align the support base assembly with the column support
7.
assembly.
Ensure that the cord channel on the bottom of the support
base faces the rear of the fan.
Ensure that the power cord is routed away from the
oscillating mechanism at the base of the fan so that the
cord is not damaged and does not prevent the fan from
oscillating.
Attach the support base assembly to the column support
8.
assembly with the four screws.
Place the cord in the wire trough in the base. The power
cord is protected by a length of plastic sleeve. Push the cord
under the strain relief in the back of the base. The sleeve
should protrude just beyond the fan support base.
Fig.3
Base
Trough &
Strain Relief
Cap
Power Cord
Screws
