www.terrateck.com
25
The bar is assembled in both
holes
(17) Tighten all the wing screws
by hand
.
(18) Fit the entire pick-up reel assembly onto the vertical tubes
of the front wheels. The pick-up reel is located above the
conveyor and the angle transmission is located on the left side
of the machine.
FLEXIBLE TRANSMISSION SHAFT
The flexible shaft is pre-assembled at the factory on its guide.
Lower part
Upper part
Lower part
Upper part
Be careful not to twist the hose: secure the
hose in place and turn the nut.
(19) Start by fixing the guide using the two pairs of nuts and washers:
(20) Screw the upper nut of the hose onto the shaft of the conveyor.
(21) Then screw the lower nut of the hose onto the angle transmission of the
pickup reel.
IMPORTANT
DRILL
To drive the RJP 80M babyleaf harvester, Terrateck recommends using the DeWALT XR 18V combi-drill, but
please note that any other
make or model may be suitable.
In any case, your combi-drill must have the following specifications:
• Voltage: 18V
• Battery Type: 4.0Ah XR Li-Ion
• Chuck size: 1.5-13 mm
• No-load speed: 1300 rpm
• Maximum torque: 60 Nm
NOTE
