Slider Pads
The front bottom slider pad should be checked daily for wear. The remainder of the slider
pads should be checked monthly for wear.
All the slider pads contain a chamfer (1) on the wearing surface. When this chamfer is worn
off, the slider pad must be replaced.
With boom extended brush grease on areas of boom where wear pads contact is evident.
he inside of the top plate of all sections except the tip section also require grease. This can
be applied through the holes in the side plates and “piled” on top of the next section out
just in front of the top rear pads on that section so that extending the boom to the next hole
smears the grease onto the inside of the top plate. Remember to do both sides.
Grease intervals vary and should be more frequent if noise or jerking of the boom is evident.
Maintenance
182
P/N 12261-319 REVISED: August 2012
Summary of Contents for RT200-1
