Terex PT-30, Service Manual

Page: 57 / 116

Figure 9-17
11. Disconnect the tubes from the side of the loader
valve. Cap and plug all openings to prevent fluid
loss.
Figure 9-18
12. Disconnect the hoses from the rear and side of the
loader valve. Cap and plug all openings to prevent
fluid loss.
Figure 9-19
13. Remove the nuts securing the valve to the reser
voir as shown.
Figure 9-20
14. Remove the valve from the machine.
15. Installation is the reverse of the removal proce-
dure.
16. Once all components have been reinstalled and
are secure, add manufacturer approved hydraulic
fluid until full mark is reached on the level gauge.
Note: To eliminate trapped air from the system, acti-
vate all hydralic circuits and run machine through its
paces including moving the lift arms up and down, curl-
ing and tilting the Q/A, driving forward and in reverse,
and activating the auxiliary circuit. Then, check
hydraulic fluid level and add as required to reach full
mark.
9-6
Compact Track Loader
9. Loader/Transmission Controls