Terex Genie Z-80/60, Operator'S Manual

Page: 63 / 80

Fifth Edition • First Printing
Operator's Manual
Operating Instructions
Part No. 1294418GT Z
®
-80/60 61
Platform Out of Level (P22 code)
Bypass key position to be used to level the
platform if ground control display shows platform
out of level (P22) and platform level controls do
not work.
To operate:
1 Turn the engine off.
2 Turn the main key switch to ground control.
Remove the key from the main key switch and
insert the key into the bypass/recovery key
switch.
3 Turn the bypass/recovery
key switch to the bypass
position.
4 Using emergency power, operate the platform
level button to level the platform.
5 Turn the bypass/recovery key switch to the run
position.
6 Remove the key from the bypass/recovery key
switch and insert the key into the main key
switch.
7 Push in and then pull out the red Emergency
Stop button.
8 If the P22 code is still visible, tag and remove
the machine from service until the fault has
been corrected by a qualified service
technician.
Tilt Sensor Activation Settings
Model Chassis Angle
(side to side) Chassis Angle
(front to back)
Z-80
5° 5°
When the Machine On Incline
indicator light is on and the tilt
alarm sounds, the following
functions are affected; drive
functions are disabled.
To restore drive functions,
follow the boom lowering
process, explained in the
previous procedure.
When the machine is stowed,
on a slope, and the tilt alarm
sounds, the following functions
are affected; lift functions are
disabled.
Return the machine to level
ground to restore lift functions.