Terex Genie Z-80/60, Operator'S Manual

Page: 46 / 80

Operator's Manual
Fifth Edition • First Printing
Inspections
44 Z
®
-80/60 Part No. 1294418GT
82 Lower the primary boom to the stowed position
or drive in the opposite direction.
Result: The alarm should turn off and the
machine should drive.
83 Return to level ground and extend the primary
boom approximately 4 ft / 1.2 m.
84 Drive the machine onto a slope where the
chassis angle is greater than 4.5° along the Y-
Axis (front to back).
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
85 Retract the primary boom to the stowed
position or drive in the opposite direction.
Result: The machine should drive.
86 Return to level ground and stow the boom.
87 With the boom fully stowed, drive the machine
onto a slope where the chassis angle is
greater than 4.5° along the Y-Axis (front to
back).
Result: The machine should continue to drive.
88 Return to level ground and raise the
secondary boom to approximately 10° above
horizontal.
89 Drive the machine onto a slope where the
chassis angle is greater than 4.5° along the Y-
Axis (front to back).
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
90 Lower the secondary boom to the stowed
position or drive in the opposite direction.
Result: The alarm should turn off and the
machine should drive.
91 With the boom fully stowed, drive the machine
onto a slope where the chassis angle is
greater than 4.5° along the X-Axis (side to
side).
Result: The machine should continue to drive.
92 Return to level ground and raise the primary
boom to approximately 10° above horizontal.
93 Drive the machine onto a slope where the
chassis angle is greater than 4.5° along the X-
Axis (side to side).
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
94 Lower the primary boom to the stowed position
or drive in the opposite direction.
Result: The alarm should turn off and the
machine should drive.
95 Return to level ground and extend the primary
boom approximately 4 ft / 1.2 m.
96 Drive the machine onto a slope where the
chassis angle is greater than 4.5° along the X-
Axis (side to side).
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.