Terex Genie Z-80/60, Operator'S Manual

Page: 47 / 80

Fifth Edition • First Printing
Operator's Manual
Inspections
Part No. 1294418GT Z
®
-80/60 45
97 Retract the primary boom to the stowed
position or drive in the opposite direction.
Result: The alarm should turn off and the
machine should drive.
98 Return to level ground and stow the boom.
99 With the boom fully stowed, drive the machine
onto a slope where the chassis angle is
greater than 4.5° along the X-Axis (side to
side).
Result: The machine should continue to drive.
100 Return to level ground and raise the
secondary boom to approximately 10° above
horizontal.
101 Drive the machine onto a slope where the
chassis angle is greater than 4.5° along the X-
Axis (side to side).
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
102 Lower the secondary boom to the stowed
position or drive in the opposite direction.
Result: The alarm should turn off and the
machine should drive.
Test the Platform Level Recovery
103 Press down the foot switch.
104 Push and hold the platform level recovery
switch up.
105 Move the platform level switch up and the level
of the platform will raise.
Result: The platform should return to a level
position.
106 Move the platform level switch down and the
level of the platform will lower.
Result: The platform should return to a level
position.
Note: The platform level switch will only work in
the direction that will return the platform to a level
position.
Test Auxiliary Controls
107 Push in the red Emergency Stop button to the
off position to shut off the engine.
108 Pull out the red Emergency Stop button to the
on position.
109 Press down the foot switch.
110 Activate the auxiliary controls. Move and hold
the switch or push and hold the button.
Activate each function control handle, toggle
switch or thumb rocker switch.
Note: To conserve battery power, test each
function through a partial cycle.
Result: All boom and steer functions should
operate.