Terex Genie Z-30N, Operator'S Manual

Page: 32 / 59

Operator's Manual Seventh Edition • First Printing
Inspections
30 Z
®
-30/20N • Z
®
-30/20N RJ Part No. 1297932GT
38 Lower the secondary boom to the stowed
position.
39 Extend the primary boom approximately 1 ft /
30 cm.
40 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the primary boom raised should not
exceed 1 ft / 30 cm per second.
41 Retract the boom to the stowed position.
If the drive speed with the primary or secondary
boom raised or the primary boom extended
exceeds 1 ft/30 cm per second, immediately tag
and remove the machine from service.
Test Drive Tilt Cutout
42 Press down the foot switch.
43 With the boom fully stowed, drive the machine
onto a slope where the chassis pitch angle is
greater than 2.5°.
Result: The machine should continue to drive.
44 Return to level ground and raise the primary
boom to an out of stowed position
(approximately 10° above horizontal).
45 Drive the machine onto a slope where the
chassis pitch angle is greater than 2.5°.
Result: The machine should stop once the
machine reaches 2.5° of chassis tilt and the
alarm should sound at the platform controls.
46 Lower the primary boom to the stowed
position.
Result: The machine should drive.
47 Return to level ground and extend the primary
boom approximately 1.6 ft / 0.5 m.
48 Drive the machine onto a slope where the
chassis pitch angle is greater than 2.5°.
Result: The machine should stop once the
machine reaches 2.5° of chassis tilt and the
alarm should sound at the platform controls.
49 Retract the primary boom to the stowed
position.
Result: The machine should drive.
50 Return to level ground and stow the boom.
51 With the boom fully stowed, drive the machine
onto a slope where the chassis pitch angle is
greater than 2.5°.
Result: The machine should continue to drive.
52 Return to level ground and raise the secondary
boom to an out of stowed position
(approximately 15° above horizontal).
53 Drive the machine onto a slope where the
chassis pitch angle is greater than 2.5°.
Result: The machine should stop once the
machine reaches 2.5° of chassis tilt and the
alarm should sound at the platform controls.