September 2016
Part No. 1272856
GTH-1256
3-19
Section 3 • Repair Procedures
How to Remove the Brake
Pedal Assembly
1 Set the ignition switch to position "1".
2 Fully depress then release the brake pedal until
the low brake pressure warning light comes on.
3 Go on depressing and releasing the brake
pedal for about one minute in order to relieve
all the pressure in the system.
4 Set the ignition switch to position "0".
5 Get behind the front right wheel and disconnect
the battery from the machine.
WARNING
Electrocution/burn hazard.
Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
6 Tag and disconnect the brake harness.
7 Tag, disconnect and plug the hydraulic hoses of
the brake pedal pump.
WARNING
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
8 Remove the retaining fasteners securing the
brake pedal. Remove the brake pedal.
How to Remove the Gauge
Cluster Assembly
1 Get behind the front right wheel and disconnect
the battery from the machine.
WARNING
Electrocution/burn hazard.
Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
2 Remove the upper part of the dashboard.
3 Reach under the dashboard and gently push
the gauge cluster through the opening in the
dashboard.
4 Tag and disconnect the wire harness from the
gauge cluster. Remove the gauge cluster from
the machine.
OPERATOR'S COMPARTMENT
