Terex Genie GS-2669 BE, Service Manual

Page: 50 / 205

Service Manual May 2015
Checklist B Procedures
34 GS-2669 BE • GS-3369 BE • GS-4069 BE Part No. 1257106
B-13
Inspect the Fuel and Hydraulic
Tank Cap Venting Systems
Genie specifications require that this procedure be
performed every 250 hours or quarterly, whichever
comes first.
Perform this procedure more often if dusty
conditions exist.
Free-breathing fuel and hydraulic tank caps are
essential for good machine performance and
service life. A dirty or clogged tank cap may cause
the machine to perform poorly and continued use
may cause component damage. Extremely dirty
conditions may require that the caps be inspected
more often.
Explosion and fire hazard.
Engine fuels are combustible.
Perform this procedure in an
open, well-ventilated area away
from heaters, sparks, flames and
lighted tobacco. Always have an
approved fire extinguisher within
easy reach.
Note: Perform this procedure with the engine off.
1 Remove the fuel filler cap from the tank.
2 Check for proper venting.
Result: Air passes through the fuel tank cap.
Proceed to step 4.
Result: If air does not pass through the cap,
clean or replace the cap. Proceed to step 3.
Note: When checking for positive tank cap venting,
air should pass freely through the cap.
3 Using a mild solvent, carefully wash the cap
venting system. Dry using low pressure
compressed air. Repeat this procedure
beginning with step 2.
4 Install the fuel tank cap onto the fuel tank.
5 Remove the breather cap from the hydraulic
tank.
6 Check for proper venting.
Result: Air passes through the breather cap.
Proceed to step 8.
Result: If air does not pass through the cap,
clean or replace the cap. Proceed to step 7.
Note: When checking for positive tank cap venting,
air should pass freely through the cap.
7 Using a mild solvent, carefully wash the cap
venting system. Dry using low pressure
compressed air. Repeat this procedure
beginning with step 6.
8 Install the breather cap onto the hydraulic
tank.