- 14 -
Checking for Leaks
1.
Make 2-3 oz. of leak solution by mixing one part liquid dishwashing soap with three parts water.
2.
Make sure control knobs are in the “OFF” position.
3.
Spray some solution on the tank valve up to the regulator connection. (See diagram to right.)
4.
Inspect the solution at the connections for bubbles. If no bubbles appear, the connection is secure.
5.
If bubbles appear, you have a leak. Proceed to step 6.
6.
Disconnect the regulator from the tank and reconnect. Make sure the connection is secured.
7.
Retest with solution.
8.
If you continue to see bubbles, replace the cylinder.
Lighting Your Grill
DANGER
Failure to open lid while igniting the grill’s burners or not waiting five minutes to allow gas to clear if the grill does not light, may
result in an explosion, which could cause serious bodily injury or death.
WARNING
Never stand with your head directly over the grill when preparing to light the main burners, to prevent possible bodily injury.
Lighting Main Burner
WARNING:
Attempting to light the burner with the lid closed may cause an explosion. Make sure there are no obstructions of airflow to the
gas unit. Spiders and insects can nest and clog the burner/venturi tube at the orifice. A clogged burner tube can lead to a fire
beneath the appliance.
1.
Open lid while lighting burners.
2.
Make sure all control knobs are in the “OFF” position.
3.
Turn on gas source or cylinder valve.
4.
Ignite only the burners you wish to use. Push and turn the knob to “HIGH” then press the igniter
button immediately. The burner should light. If the burner does not light, repeat 2 or 3 times.
5.
If ignition does NOT occur in 5 second turn the burner controls to OFF, wait 5 minutes, and repeat
the lighting procedure.
6.
To ignite remaining burners, repeat the step 4 and 5 for each burner.
7.
Adjust valve knob(s) to desired cooking temperature.
Using the Lighting Stick to Light the Main Burners
1.
Insert a match into the end of lighting stick. Light the match.
2.
Once lit, put the lighting stick through the hole on the grill body
to reach the burner ports (See diagram to right.)
3.
Press the valve knob and rotate it counterclockwise to the ‘’HIGH’’ position.
The burner should light immediately. If more than one burner is desired, repeat
the procedure 2-3 until all desired burners are lit.
4.
Adjust burners to the desired cooking temperature.
PRECAUTIONS:
1.
After lighting, observe the burner flame. Make sure all burner ports are lit.
2.
If the burner flame goes out during operation, immediately turn the gas “OFF”. Open lid to let the gas clear for at least 5
minutes before re-lighting.
3.
Before cooking on the grill for the first time and operate the grill for approximately 15 minutes with the lid closed and the
