TER 206, Operating Manual

Page: 23 / 56

OPERATING MANUAL OPERATING MANUAL
English
GB
English
GB
GB GB
SWITCH CYCLES – Setting
TIMER
The current stops
after the set time;
can restart with a
new arc strike.
Available both
with lift and HF
arc strike mode
TWO STEPS
The current starts
when the torch
switch drives the
cycle and stops
when it is relea-
sed. Up and down
slopes are not
allowed
TWO STEP
SLOPE
The current starts
when the torch
switch drives the
cycle and stops
with a down slope
when the torch
switch is released
FOUR
STEPS
The current starts
when the torch
switch drives the
cycle and stops
when the torch
switch is pressed
again
FOUR
STEPS SLO-
PE
The current starts
at level 1 at the
first torch switch
pressure; slope
rise up releasing
the torch switch.
Down slope to
current I3 at
second switch
pressure and
stop with switch
release.
NOTES:
In synergic tig setting all the parameters change according to program and current:
PREGAS
fix at 0,1 sec
UP slope automatic depending from down slope
CURRENT 1 automatic sinergic
CURRENT 3 automatic sinergic
DOWN slope automatic sinergic
POST GAS automatic sinergic
PULSE FREQUENCY automatic sinergic
PULSE BALANCE automatic sinergic
TIMER variable (select the icon with second level pushbutton)
PULSE PEAK automatic sinergic
PULSE LOW CURRENT automatic sinergic
THE USER DOES NOT NEED TO ADJUST THE WHOLE PARAMETERS BECAUSE THEY ARE ALREADY SET AT THE OPTI-
MAL VALUE
CORRECTION OF THE SYNERGIC PARAMETERS
If expert users need any particular adjustment, corrections of down slope, frequency, post gas are allowed chan-
ging the program values.
Press the second level pushbutton up to the icon “SLOPE DOWN” ligth on, than adjust the parameters between
-50% and +50% by pressing pushbutton “+” or “ –“.
Press the second level pushbutton up to the icon “POST GAS” ligth on, than adjust the parameters between -50%
and +50% by pressing pushbutton “+” or “ –“.
Follow the same procedure for frequency.