TER 206, Operating Manual

Page: 16 / 56

OPERATING MANUAL OPERATING MANUAL
English
GB
English
GB
GB GB
TIG WELDING – machine setting
Connect the tig torch to the negative
polarity
Connect the auxiliary plug (if the
machine is provided with the remote
control socket)
Connect the torch gas hose to the
output nipple (if the machine is
equipped with gas control)
Connect the argon gas bottle to
the input gas nipple located on the
machine back side and adjust the
gas flow between 5 to 7 liters per
minute
Connect the
workpiece earth
cable to the positive
polarity
LIFT ARC MODE
Push the torch switch. If the solenoid gas valve is not
controlled by the torch switch, open the gas flow.
Slow down the torch until the ceramic nozzle touch the
workpiece; in this phase held the torch and avoid any
contact between tungsten and workpiece.
Keeping the nozzle in contact, turn the torch until the
tungsten enters in contact with the workpiece
Maintaining the nozzle-work piece contact, turn back
the torch to the original position; the arc strikes and the
welding can be performed.