Teo 4104, Installation Instructions Manual

Page: 17 / 76

Installation
13-280131 Rev. J Page 17
I
I
n
n
i
i
t
t
i
i
a
a
l
l
i
i
z
z
a
a
t
t
i
i
o
o
n
n
w
w
i
i
t
t
h
h
o
o
u
u
t
t
D
D
H
H
C
C
P
P
S
S
e
e
r
r
v
v
e
e
r
r
The DHCP (Dynamic Host Configuration Protocol) server automatically assigns the
telephone address, server addresses, and subnet mask. If DHCP is not available, or is not
provisioned with all of these parameters, they must be entered manually.
The following display will be shown while the phone attempts to connect to a DHCP server.
•
If no DHCP server is available, select DISABLE to use static addressing.
•
Select EDIT.
•
Select CLEAR to remove the displayed IP address. Enter the phone’s IP address with
the dial pad; use the * key to enter a ".". Press the
OK
key when finished.
•
Enter the required subnet mask and gateway IP address when prompted; press the
OK key after each entry.
Next, the phone will prompt for an update server protocol and IP address.
•
Select a protocol, and then enter the update server IP address. Press the
OK
key
when finished. If no update server is available, select NONE.
The phone then will prompt for the Line ID, authentication ID, and SIP password as shown
on the previous page.
SELECT UPDATE SERVER: ¤
NONE
SELECT UPDATE SERVER: ¤
TEO TFTP HTTP HTTPS
IP4 ADDR=000.000.000.000
DELETE CLEAR PING4
IP4 ADDR=000.000.000.000
EDIT
CHECKING DHCP
DISABLE