LOCO CONTROL: (SCREEN-A)
Press [ <<T ]” or “ [ T>> ] to select to desired CAB number.
Increase speed: Press the [UP arrow] button.
Decrease speed: Press the [DOWN arrow] button.
Locomotive direction change: Press the [LEFT arrow] or [RIGHT
arrow] button. To change the speed step go to the QUICK MENU.
If Transmitter is successfully linked to the receiver, the link status
should be displayed LINKOK on the display screen item
①
and
⑩
.
If the CAB number is selected (1) and it was selected to the consist
mode it should display CAB-1C otherwise CAB-1S.
Display item number
③
Consist OFF mode: display
PROFI-n
(n=Profile number ,1 to 25)
Consist UNI mode: display
UNI-CON
Consist ADV mode: display
ADVnnn
(nnn=Advanced consist short
address number)
QUICK PROGRAM: (SCREEN-B)
While operating in the LOCO CONTROL mode, press the [ * ] button.
Then the screen will be changed to the “QUICK PROGRAM” mode.
Press the MENU button to exit.
a)
ACCELERATION (CV3)
Press the number buttons between 0 to 255 and then press the STOP
button.
b)
DECELERATION (CV4)
Press the number buttons between 0 to 255 and then press the STOP
button.
c) PROGRAM:
Press STOP button then the LCD screen will be changed
LOCO PROGRAM
menu screen.
d) RX STATION POWER LIMIT:
This value is for maximum RX power value. It can be changed from 25%
to 100%. Press LEFT arrow button to decrease and RIGHT arrow button to increase
the value. The default power value is 75%.
LOCO PROGAM MODE: (SCREEN-C)
There are two types of DCC programming mode.
(a)
PROG MODE:
Press [STOP] button to toggle between TRACK or MAIN function.
TRACK (Service mode) PROGRAMMING :
Press the [STOP] button, if successfully written the data to the decoder then
the LCD shows “ACK OK”
(Note: The locomotive must placed on the programming track)
2.4GHz DCC R/C System
<
TENTATIVE>
8
SCREEN-A
SCREEN-B
SCREEN-C
