Tentative 59001, Installation And Operation Manual

Page: 12 / 17

1.4)
ADDR PROGRAM ( SCREEN-5 )
Press the [STOP] button to enter Address Program Mode.
You can
program the Locomotive short or long DCC address and the advanced
consist will be cleared to 0 (the CV19 will be set to 0)
➢
PROGRAM MODE :
Address programming allows the TRACK programming mode only.
➢
READ:
This function allows to read the address value from the decoder.
➢
NEW ADDR:
You can change the new decoder address.
Press ◄ to set
SHORT address, Press ► to set LONG address
Use the keypad to type numbers to new address.
➢
WIITE:
Press the [STOP] button to send the write data packet to the decoder. In the TRACK programming mode If the
data is written successfully to the decoder then the LCD displays “ACK OK”
In the
MAIN programming mode: The LCD displays “SENT PACKET”
Press the [STOP] button to enter CV PROGRAM
1.5)
CV PROGRAM : ( SCREEN-6 )
LOCO PROGRAM S**3
➢
PROG MODE:
Press the [STOP] button to select the TRACK or MAIN programming mode.
➢
CV NUMBER:
Use the keypad to type numbers to CV number(1 to 1024)
➢
CV VALUE:
Use the keypad to type numbers to CV value(0 to 255)
If the [STOP] button press, the CV value is set in bit-wise.
(see the “
BINARY INPUT ”). “ Screen-7 ”
➢
READ:
Press [STOP] button to read CV value.
(Note:The read function allows at the TRACK mode only)
➢
WRITE:
Press [STOP] button to send the write packet to the decoder.
If successfully written the data to the decoder then the LCD displays “ACK OK”.
BINARY INPUT: (SCREEN-7)
The CV value can be set in bits.
Press the number on the keypad to set the corresponding bit to '1' or '0'.
Press the [MENU] or [STOP] button to return to the previous menu.
2. CAB/LOCO ASSIGN: (SCREEN-8)
Press the [STOP] button to enter the Cab/Loco Assign.
Each locomotive must be assigned to a cab number. This provides a simple
way to choose locomotives from the main LOCO CONTROL operating screen.
2.1) MAX USED CAB #:
Press ◄ or ► button to select the desired maximum used CAB numbers.
2.2) CURRENT CAB #:
Press ◄ or ► button to select the desired current CAB number to program.
2.3) CONSIST MODE:
Press ◄ or ► button to select consist mode as shown below.
OFF :Single Locomotive mode
UNI : Universal Consist mode
ADV :Advanced consist mode
2.4GHz DCC R/C System < TENTATIVE> 12
SCREEN-5
SCREEN-6
SCREEN-7
SCREEN-8
SCREEN-9