CHASSIS
2-14
7200 330045 (10--99)
18. Locate the area where the brake cable
attaches to the drive support. The beginning
adjustment should be
1.375 in.
of conduit
showing on the cable end.
19. Turn the steering wheel all the way to the
right.
NOTE: Spin the tire/wheel assembly to make sure
the brakes are not dragging with the brake pedal
NOT engaged.
20. Go to the other side of the drive assembly
and install the planetary gear box, outer
plate, and motor assembly into the wheel
assembly and onto the pins of the drive
assembly.
21. Install the 4 hex screws and washers.
Tighten to 18 -- 24 Nm (15 -- 20 ft lb).
22. Reconnect the electrical cables to the drive
motor.
23. Remove the jack stands and lower the
machine.
24. Reconnect the battery cables.
25. Drive the machine and check the brakes for
proper operation. Adjust if necessary.
Summary of Contents for 7200
