14
www.templari.com
6.3 Free spaces for the assembly
Distance
Measures in millimeters
A
>300
B
>2500
C
>300 KITA S >400 KITA M >500 KITA L
D
>3000
E
>1000
Respect the minimum distances mentioned above to ensure a
sufficient air flow and facilitate maintenance works.
•
Verify there is asufficient space for the installation of the
hydraulic piping.
•
If the product is installed in areas prone to heavy snowfalls,
verify the snow doesn’t accumulate around the product
and the minimum distances mentioned above are
respected. If these conditions can’t be satisfied, install then
an additional heat generator in the heating circuit.
6.4 Choice of installation place
•
Observe all the rules in force.
•
Install the product outside the building.
•
Don’t install the product:
- near a heat source,
- near flammable substances,
- near ventilation opening of contiguous buildings,
- Below deciduous trees.
•
For the installation of the product observe:
- prevailing winds,
- noise of the fan and the compressor,
- optical impression on the environment
•
Avoid place where on the air outlet of the product there is
the effect of strong winds.
•
Don’t orient the fan towards the near windows.
•
If necessary, install noise-protection system.
•
Install the product on one of the following supports:
- Concrete pavement,
- T steal beem
- Concrete block.
•
Don’t expose the product to dusty and corrosive air (e.g.
near rough roads).
•
Don’t install the product near wells of air discharge.
•
Prepare the laying of electrical cables.
•
In places where there are snowfalls, install the heat pump
at least 25 cm from the ground to avoid clogging at the
inlet and drain zone.
6.5 Assembly of the heat pump
1. Before installing the product, observe the safety warnings
content in this manual and service manuals.
2. Assembly the product on steel beams, blocks of concrete
or with the help of a wall holder (accessory).
3. Verify that under the product water doesn’t accumulate
non si accumuli.
4. Verify that the floor in front of the product can well absorb
water to avoid ice formation.
6.6 Preparation of the condensate drain
The condensate is discharged in a centralized way from the back
of the heat pump
KITA Templari®.
Prepare the condensate drain through a drain pipe or a gravel
bed.
WARNINGS!
The condensate frozen on the avenues can cause falls. Verify that
the condensate doesn’t flow on the avenues and can’t freeze on
them.
Frost proof
depth
min 200mm
Frost
proof
depth
Frost proof
depth
min 200mm
Frost
proof
depth
