TEMA TELECOMUNICAZIONI SRL
Doorphone AA-539
MAS-AA539-REV02EN
Page 23 of 57
Complete OUTDOOR BOX (Accessory option AA-549-S)
The complete box is a cover that completely houses the AA-539
system, both the front panel which is protected as using the AA-
549-T shield, and also the inner metal rear box of the system.
Using the accessory AA-549-S it is no longer necessary to recess
the rear metal box of the system. The entire system will be housed
in the metal box AA-549-S and will be on the surface of the wall.
The complete box, unlike the other two previously described accessories, presents a radically different mode of
assembly. The tubes with electrical cables for the system should not be taken to the inner metal box but directly to
one of the holes on the back (case with cables not visible) or face down of the cover (case of exposed pipe).
Take the box from its packaging and place it on a work surface.
•
Remove the front frame "CF", unscrew the 4 screws "A" on the bottom releasing the inner metal shell "GM" and
remove it.
•
Open the holes "B" if you want to use them for securing on the wall the full metal box "SC" with the help of a
tool that pushes away the preprinted material that covers every single hole to be released.
•
To further enhance fixing, plans to use also the four holes labeled "A" (in the central photo) to secure the inner
metal shell and the external box with dowels inserted here (in this case consider whether or not to use the four
holes labeled "B"). You must use "A" holes anyway.
•
Open also the holes "C" that you want to use for the passage of cables, in the same way.
•
Place the protection metal box "SC" directly on the wall to mark the holes to be made for fixing it. Perform
drillings on the wall for the provided anchors for fixing, finally place the metal box and tighten the screws of the
anchors to secure it to the wall.
•
Having previously defined the openings for cable entry on the metal box, open the corresponding pre-drilled
"C" also on the back inner metal shell "GM". It is possible to use one hole on the top or the one on the bottom
of the rear (properly orienting the metallic shell "GM") and one on the lower side of the full metal box "SC".
•
Tighten the four screws "A" of the metal back "GM" to the metal box "SC" to reassemble it inside the protective
metal cover and re-seal the base of the front panel of the system.
•
Proceed to connect the cables to the system board (see connections section).
For the closing of the system after the cable connection and commissioning, support the front frame "CF", align the
two pins of transparent plastic of the front frame of the system on their insertion holes on the left side of the front
flat frame "CF ", insert gently until it stops.Then rotate all over the front panel to close the box and get ready to
tighten the 4 special screws planned for this purpose. Ensure that the panel rests firmly on its aluminum frame, and
accompany the cables verifying that are properly seated and not get caught between the front and rear walls of the
half-shell.
GM
CF
A
B
SC
C
A
