5
•
SMS forwarding
The module can forward incoming SMS messages to the first user phone number. SMS
forwarding function is enabled by default, if not necessary, can be disabled in the settings
menu. SMS forwarding is limited to 5 messages per day.
•
Monitoring station phone number
The module supports 1 monitoring station phone number, where it reports all events
using Contact-ID protocol. The maximum length of the phone numbers should not
exceed 16 characters and international format should not contain “+” character
(e.g. 0036….). Already set phone number can be erased by pressing the „
#
” key instead
of entering a new number.
•
Event codes and SMS texts
A Contact-ID event code (3 digits) can be assigned to each event, which identifies the
event at the monitoring station. The SMS texts for events are preset according to the
following table, but can be modified by sending command SMS to the module. The
default settings for event codes and SMS texts are the following:
Event
Contact-ID event code
SMS text
Alarm input 1
130
ALARM1
Alarm input 2
130
ALARM2
Low supply voltage
302
LOW VOLTAGE
Voltage restore
302
BATTERY OK
Periodic test report
602
TEST REPORT
•
User account ID
The user account ID is a 4 digit identifier which is necessary for reporting to monitoring
station and is supplied by the monitoring station. The module supports only decimal
characters. Default setting: 0000.
•
Recordable voice messages
For each of the two inputs a voice message can be recorded with a maximum length of 6
seconds each. If no message is recorded, the module uses instead a built-in siren tone
when calling the user phone numbers. The recorded voice messages cannot be erased
separately, are automatically replaced with the built-in siren tone if the settings are
restored to factory default (module reset).
•
Caller identification
Caller identification is a security function useful in the course of relay remote control. If
enabled, the module checks the caller’s phone number and activates the relay only when
called from one of the 4 user phone numbers. For this it is essential to have the phone
number information sending service enabled on the caller’s SIM card and in the phone as
well. At the same time, phone number information detection service must be enabled on
the SIM card placed into the module. The caller identification function is disabled by
default, so the relay output may be activated from any phone number.
