GL865-DUAL V3 Hardware User Guide
1vv0301018 Rev.5 – 2013-08-05
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights Reserved.
Page 26 of 76
Mod. 0805 2011-07 Rev.2
6.3.
General Design Rules
The principal guidelines for the Power Supply Design embrace three different design steps:
•
the electrical design
•
the thermal design
•
the PCB layout.
6.3.1.
Electrical Design Guidelines
The electrical design of the power supply depends strongly on the power source from which
this power is drained. We will distinguish them into three categories:
•
+5V input (typically PC internal regulator output)
•
+12V input (typically automotive)
•
Battery
6.3.1.1.
+ 5V input Source Power Supply Design Guidelines
•
The desired output for the power supply is 3.8V, hence there's not a big difference
between the input source and the desired output and a linear regulator can be used. A
switching power supply will not be suited because of the low drop out requirements.
•
When using a linear regulator, a proper heat sink shall be provided in order to dissipate
the power generated.
•
A Bypass low ESR capacitor of adequate capacity must be provided in order to cut the
current absorption peaks close to the GL865-DUAL V3
, a 100μF tantalum capacitor is
usually suited.
•
Make sure the low ESR capacitor on the power supply output (usually a tantalum one)
is rated at least 10V.
•
A protection diode should be inserted close to the power input, in order to save the
GL865-DUAL V3 from power polarity inversion.
An example of linear regulator with 5V input is: