
Telit EVK2 User Guide
1vv0300704 Rev.13- 2012/06/25
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page
53 of 149
“SEPARATED SERIAL PORT”
This set the
SIRF Binary
available on the USB connector.
GE863-GPS
4
4
PL103
P
L102
P
L101
1
1
PL104
39 40
1151_3c.skd
S
O
106
Figure 29: Jumpers setting for SIRF BINARY port available on USB connector
NOTE:
In this configuration soma AT GPS commands are not available. Refer to AT Commands
Reference User Guide.
15.7.
ANTENNA connectors
15.7.1.
GPS ANTENNA connector
An active GPS antenna should be connected to SO104; the GPS section provides
the
DC feeding.
WARNING:
Don’t connect a
GSM
antenna on this connector
15.7.2.
GSM ANTENNA connector
A GSM antenna should be connected to SO103.
15.7.3.
RFU ANTENNA connector
On PCB there is the mounting possibility of a further RF connector (
SO105
): it is
related to future implementation.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from