IP-223 to RTS Intercom Products
AN-DISPATCH-035
19
5.2
IP-223 Remote Setup
The remote IP-223 must be configured for local mode operation on both lines.
NOTE:
The IP-223’s default username is
admin
and the password is blank.
REFERENCE:
For more information, see the IP-223 Technical Manual (P/N803641) for
jumper settings relevant to the RTS equipment to be connected.
5.2.1
Remote IP-223 Multicast Address Setup Window
NOTE:
Both Unicast and Multicast are supported for this feature.
See examples shown in Figure 11 and Figure 13.
To
configure a unicast system
, do the following:
1. From the remote IP-223 configuration webpage, click
Multicast Address Setup
.
The Multicast Address Setup window appears.
2. Enter the
static IP Address
of the local IP-223 in:
Line 1’s Rx and Tx Mcast Address fields.
Line 2’s Rx and Tx Mcast Address fields.
3. Click
Submit
.
The Multicast Address Setup configuration is temporarily saved.
4. Click
Save to EEPROM
.
The EEPROM window appears.
5. Click
Save Parameters
.
All configurations are permanently saved to the IP-223 console.
To
configure a multicast system
, do the following:
1. From the remote IP-223 configuration webpage, click
Multicast Address Setup
.
The Multicast Address Setup window appears.
2. Enter the same
Multicast Address
used in the local IP Setup in:
Line 1’s Rx and Tx Mcast Address fields.
Line 2’s Rx and Tx Mcast Address fields.
3. Click
Save to EEPROM
.
The EEPROM window appears.
4. Click
Save Parameters
.
All configurations are permanently saved to the IP-223 console.
NOTE:
The range for Multicast Addresses is
224.0.0.2
to
239.255.255.255.
