Telesis PINSTAMP TMP4100 Series, Installation & Maintenance, Page: 45 / 62

TMP4100-Series Installation/Maintenance
33480D01.DOC
2-17
Installation
1. Install the new solenoid valve assembly. Ensure the gasket is properly positioned.
2. Route the solenoid wires toward the upper, backside of the X-axis motor and push the plugs onto limit
board connectors J6 and J7.
3. Install the marking unit into left cover and secure with three flat head screws.
4. Connect the marking unit cable connector J2 to J1 on the limit board.
5. Attach the ground lug.
6. Connect tubing to bulkhead fitting. Do not kink the tubing.
7. Install the handle mount onto left cover (with radius end of handle toward the back of the marker).
Secure with two M4-0.70 x 16 socket head cap screws.
8. Slide the handle onto the handle mount and tighten the set screw.
9. Install the push button switch assembly (connector end first) through the switch mounting hole.
10. Route the switch wires in and upward through the clearance hole toward the limit board.
11. Connect the switch wires to J2 on the limit board.
12. Secure the switch to the handle with a M3-0.50x3 set screw.
13. Lay the flex snap in the strain relief bushing on the cable assembly in the half-hole in the back of the left
cover with the tab facing down into the half-hole.
14. While holding the bushing in place, lay the right cover on top.
Ensure the push button wires are not pinched between the covers.
15. Secure the right cover with four M3-0.50 x 25 socket head cap screws.
16. Install the standoffs. (see replacement procedure)