Telemotive telePendant, Programming And Users Manual, Page: 23 / 31

Section 5 – Programming (Continued)
23 8/2/2004
H. Multibox (Optional, skip if you do not wish to use
the Multibox feature):
Do not use on InteleSmart Receivers. Use Group Code
feature see InteleSmart Receiver Manual.
See Section 5-2. Multibox for details on Multibox
programming. If your current receiver does not have
Multibox do not attempt to use this function. This
function WILL NOT turn Multibox on in the receiver. It
only assists you in programming the correct transmitter
access code for a receiver that already has Multibox.
Make sure when you are using the Multibox feature that
the access code of the receiver is programmed into the
access code above and not one copied from an existing
transmitter on a Multibox system. If you cannot find the
receiver transmitter code and wish to copy existing
transmitter on a Multibox system, put the transmitter’s
access code in the access code switches above and DO
NOT check the Multibox box on the PDA.
Select the Tx # this should be the next number in the
series of transmitter being put on a Multibox system. If
the are two transmitters on already and you are adding a
third, select the number 3. Make sure as stated in the
Multibox section the receiver is programmed for the
appropriate number of transmitters.
The Tx # goes up to 8. Many Multibox systems only go
to four. Check with your Telemotive representative if
you need more then 4 transmitters on a Multibox system.
I. Set Time-Out–Timer Time. Default time is 15
minutes.
The time it takes the transmitter to shutoff due to un-use
is programmable. Tap the arrow next to the word
“Timer” to program and scroll through the numbers
shown. Units shown are in minutes.
J. Active ESTOP.
This feature causes the Receiver to shutdown if the
transmitter is out of range. For this to work the
companion receiver must have this feature also. Please
check the receiver manual. All InteleSmart receivers
have this feature, both the receiver and the transmitter
must have this box checked. DO NOT use this feature
with non equipped receivers. It is not recommended to
have multiple transmitters on the same channel if Active
ESTOP is used due to the additional channel loading.
K. Auto Turn Off. (Normally Leave Checked).
Auto Turn Off causes the unit to send an OFF command
to the receiver if the battery goes bad or the transmitter
times out. Removing the check from this box disables
this feature.
L. Go to the appropriate Section for your system.
5-3.3 2-Speed
telePendant
, Page 24.
5-3.4 3-Speed telePendant , Page 26.
5-3.5 3-Speed 10K Pendant, Page 27.
System 10K Freq AK01
Setup Bank #
A1
Receiver access code
1
0 B1 1
0
S3-1
1
0
Timer
Switch conf.: H,T,B
Main/Aux Aux
only
Save
Cancel
Multibox
Auto Turn Off Active ESTOP
RX Setting
15
Tx # 1
telePendant Multibox Pro g rammin g .
Multibox
Programming
Timer
15