Telematrix Spectrum Plus SP100, User Manual

Page: 18 / 30

To install the wedge for desk mounting, be sure the lock mechanism is positioned to the left clear of the
locking arm. Place the wedge in the slots, wide end toward top of phone base unit, and slide the wedge
upward into position. Lock the wedge into place.
18
The SpectrumPLUS
TM
was designed to be conveniently
wall mounted without requiring additional hardware.
Follow these easy steps:
Wall Mounting the SpectrumPLUS TM Telephone
1.The handset retaining clip must be in the correct
position to secure the handset into the handset cradle.
To engage the clip, pull the clip forward (outward) with
your fingers, rotate the clip 180º and snap the clip back
into place (figure 1). The retaining clip cannot be
removed because it is spring loaded.
2. The SpectrumPLUS
TM
has provisions for a mounting
wedge that must be correctly positioned. This wedge
allows the telephone to be viewed at a correct angle
when the phone is wall mounted. Remove the wedge
from the phone base (figure 2).
3. Secure the w iring in place prior to installing the wall
mount wedge. The wall mount base has extra large
wiring channels and strain relief poles for containing
the wires in a neat and orderly way. Wrap the wires
around the strain relief poles and then secure the wires
through the channel.
4. To wall mount, place the narrow edge at the top edge
of the phone base and slide the wedge upward into
place (figure 3).
5. Lock the wall mount into position by sliding the
locking button to the right (figure 4).
Retaining Clip
figure 1
figure 2
Remove Mounting Wedge
figure3
Replace Mounting Wedge
figure 4
Lock Mounting Wedge
1. UNSNAP
2. ROTATE 180 .
3. SNAP INTO PLACE.
Note: A 6 inch line cord is provided for wall
mount installation. Connect one end of the
line cord to the phone jack and the other end
to the wall jack.
!
Desk Mounting
CLIP IS SPRING LOADED
PULL OUTWARD
Mounting Wedge Spectrum Plus Bottom
Mounting Wedge
Spectrum Plus Bottom
Mounting Wedge
Spectrum Plus Bottom
Lock mounting wedge