7
Consumer Information:
This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the
bot-
tom
of this equipment is a label that contains, among other information, a product identifier in the format
US:
2N3MT05B19100
If requested, this number must be provided to the telephone company.
An applicable certification jacks Universal Service Order Codes (USOC) for the equipment is provided (i.e.,
RJ11C
) in the packaging with each piece of approved terminal equipment.
A plug and jack used to connect this equipment to the premises wiring and telephone network must comply with
the applicable FCC Part 68 rules and requirements adopted by the ACTA. A compliant telephone cord and
modular plug is provided with this product. It is designed to be connected to a compatible modular jack that is
also compliant. See installation instructions for details.
The REN is used to determine the number of devices that may be connected to a telephone line. Excessive
Ringer Equivalences on a telephone line may result in the devices not ringing in response to an incoming call. In
most but not all areas, the sum of Ringer Equivalences should not exceed five (5.0). To be certain of the number
of devices that may be connected to a line, as determined by the total Ringer Equivalences, contact the local
telephone company. [For products approved after July 23, 2001, the Ringer Equivalence for this product is part
of the product identifier that has the format
US:
2N3MT05B19100
The digits represented by 05 are the Ringer
Equivalence without a decimal point
(e.g
., 05 is a REN of 0.5). For earlier products, the Ringer Equivalence is
separately shown on the label.]
If this equipment
19100/191001
causes harm to the telephone network, the telephone company will notify you in
advance that temporary discontinuance of service may be required. But if advance notice isn't practical, the tele-
phone company will notify the customer as soon as possible. Also, you will be advised of your right to file a com-
plaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations or procedures that could af-
fect the operation of the equipment. If this happens the telephone company will provide advance notice in order
for you to make necessary modifications to maintain uninterrupted service.
Please follow instructions for repairing if any (e.g. battery replacement section); otherwise do not alternate or
repair any parts of device except specified.
Connection to party line service is subject to state tariffs. Contact the state public utility commission, public ser-
vice commission or corporation commission for information.
This equipment is hearing aid compatible.
NOTICE:
If your home has specially wired alarm equipment connected to the telephone line, ensure the installa-
tion of this
[equipment ID]
does not disable your alarm equipment. If you have questions about what will disable
alarm equipment, consult your telephone company or a qualified installer.
Should you experience trouble with this equipment, please contact
(
TeleMatrix, Inc.Customer Care Center 5025
Galley Road Colorado Springs, CO. 80915 . Toll Free:1-800-462-9446 Direct:719-638-8821 Fax:719-638-
8815 www.telematrixusa.com
)
for repair or warranty information. If the equipment is causing harm to the tele-
phone network, the telephone company may request that you disconnect the equipment until the problem is re-
solved.
[NOTICE:
According to telephone company reports, AC electrical surges, typically resulting from
lightning strikes, are very destructive to telephone equipment connected to AC power sources. To
minimize damage from these types of surges, a surge arrestor is recommended.
]
Summary of Contents for Spectrum Plus SP100
