Teledyne TIENet 360 LaserFlow Ex, Installation And Operation Manual

Page: 130 / 140

TIENet™ 360 LaserFlow™ Velocity Sensor
D-4
101 Christine Drive
Belen, New Mexico 87002
Phone: (505) 864-6691
Fax: (505) 861-2355
MATERIAL SAFETY DATA SHEET -- September 28, 1998
SORB-IT
®
Packaged Desiccant
ISO 9002
NOTE TO PHYSICIAN : This product is a desiccant and generates heat as it adsorbs
water. The used product can contain material of hazardous nature. Identify that material
and treat accordingly.
SECTION VI -- REACTIVITY DATA
Reactivity - Silica gel is stable under normal temperatures and pressures in sealed
containers. Moisture can cause a rise in temperature which may result in a burn.
SECTION VII --SPILL OR LEAK PROCEDURES
Notify safety personnel of spills or leaks. Clean-up personnel need protection against
inhalation of dusts or fumes. Eye protection is required. Vacuuming and/or wet methods
of cleanup are preferred. Place in appropriate containers for disposal, keeping airborne
particulates at a minimum.
SECTION VIII -- SPECIAL PROTECTION INFORMATION
Respiratory Protection - Provide a NIOSH/MSHA jointly approved respirator in the
absence of proper environmental control. Contact your safety equipment supplier for
proper mask type.
Ventilation - Provide general and/or local exhaust ventilation to keep exposures below
the TLV. Ventilation used must be designed to prevent spots of dust accumulation or
recycling of dusts.
Protective Clothing - Wear protective clothing, including long sleeves and gloves, to
prevent repeated or prolonged skin contact.
Eye Protection - Chemical splash goggles designed in compliance with OSHA
regulations are recommended. Consult your safety equipment supplier.