Teledyne PIXIS-XF, System Manual

Page: 84 / 116

84 PIXIS-XF System Manual Issue 5
7.11 Device Is Not Found
When LightField is launched, it looks for devices (i.e., cameras, spectrometers, and
filters,) that are powered on and connected via a communications interface to the host
computer. If LightField cannot find a device that was used in the last experiment, it will
display the dialog showin in
Figure 7-6 as it continues searching for it until you connect
and power the device on or you cancel the load.
Figure 7-6: Typical LightField Devices Missing Dialog
• Verify that the device is connected and powered on. If the device is connected
but turned off, switch it on. LightField should now find the device. If it does not,
cancel the load and restart LightField.
• Cancel the load. Canceling a load means that the last used experiment will not
be loaded automatically when LightField opens. However, you can load the
experiment after all the devices are available, you can start a new experiment
design, or you can load a different experiment that matches the devices you are
using.
4
4
11
-0
112_
005
2