Teledyne 3010MA, Operating Instructions Manual

Page: 43 / 88

Paramagnetic O2 Purity Analyzer Operation
Teledyne Analytical Instruments
43
• Setup Auto-Cal
• Assign Password
• Initiate Self-Test
• Check software version
• View sensor output
• Log out.
•
Zero
. Used to set up a zero calibration.
• Span. Used to set up a span calibration.
•
Alarms.
Used to set the alarm setpoints and determine whether
each alarm will be active or defeated, HI or LO acting,
latching, and/or failsafe.
•
Range.
Used to set up three analysis ranges that can be
switched automatically with auto-ranging or used as individual
fixed ranges.
Any function can be selected at any time by pressing the appropriate
button (unless password restrictions apply). The order as presented in this
manual is appropriate for an initial setup.
Each of these functions is described in greater detail in the following
procedures. The VFD screen text that accompanies each operation is
reproduced, at the appropriate point in the procedure, in a
Monospaced
type style. Pushbutton names are printed in
Oblique
type.
4.3 The System Function
The subfunctions of the
System
function are described below.
Specific procedures for their use follow the descriptions:
• Auto-Cal: Used to define an automatic calibration sequence
and/or start an Auto-Cal.
•
PSWD:
Security can be established by choosing a 5 digit
password (
PSWD) from the standard ASCII character set. (See
Installing or Changing a Password, below, for a table of ASCII
characters available.) Once a unique password is assigned and
activated, the operator MUST enter the UNIQUE password to
gain access to set-up functions which alter the instrument’s
operation, such as setting the instrument span or zero setting,
adjusting the alarm setpoints, or defining analysis ranges.