TELEDYNE OLDHAM SIMTRONICS Everywhereyoulook DG-TT7-S, Operating Manual

Page: 25 / 72

MULTITOX DETECTOR
OPERATING MANUAL
NOSP17668
Revision 03
a
19
4.3.1 Connection of the electrical ground braid
Use a shield connection clamp (not supplied) to connect the shielding of the cable to the electric
ground of the housing (see § below).
4.3.2 Grounding
A M4 screw passes through the body of the enclosure, enabling the electronic ground of the
housing to be connected to the local ground.
It is recommended to use a yellow / green wire with a ring lug (section ≥ others wires and ≥1.5
mm²). The armour of the power cable is normally connected to the ground of the detector, but it
may depend on site practices.
4.3.3 Connection
There are three different type of power supply:
•
3-wires connection (source):
-
The output current is not isolated from power supply, provided from detector
(standard connection).
•
3-wires connection (sink):
-
The output current is not isolated from power supply, consumed by the detector
•
4-wires connection:
-
The output current is isolated from power supply
NB :The power potentials are isolated fromthe electric ground of the housing.
Total loop resistance:
Whatever the power supply type (3 wires source ou sink, 4 wires), the total loop resistance
(re cable) should not exceed the following value:
mA 22
V 8 tage supply vol Power
maxi R
−
=
The total loop resistance should not exceed 700
Ω
with a voltage of 24Vdc