WavePro HD Getting Started Guide
3
CAUTION
of potential damage to equipment, or
WARNING
of potential bodily injury.
Do not proceed until the information is fully understood and conditions are met.
WARNING
. Risk of electric shock or burn.
Measurement ground connection.
Alternating current.
Power On/Standby (Off).
Safety
Operating Environment
Power
* All active probes and peripherals installed.
Symbols
Precautions
Observe generally accepted safety procedures in addition to the
precautions listed here.
Use proper power cord.
Use only the power cord shipped with this
instrument and certified for the country of use.
Maintain ground.
This product is grounded through the power cord
grounding conductor. To avoid electric shock, connect only to a grounded
mating outlet.
Connect and disconnect properly.
Do not connect/disconnect probes or
test leads while they are attached to a live voltage source.
Observe all terminal ratings.
Do not apply a voltage to any input that
exceeds the maximum rating of that input. Refer to the markings next to
the BNC terminals for maximum allowed values.
Use only within operational environment listed.
Do not use in wet or
explosive environments.
Exercise care when lifting and carrying.
Unplug and use the built-in
carrying handle to move the instrument.
Use indoors only.
Keep product surfaces clean and dry.
Do not block the cooling vents.
Leave a minimum six-inch (15 cm) gap
between the instrument and the nearest object. Keep the underside clear
of papers and other objects.
Do not remove the covers or inside parts.
Refer all maintenance to
qualified service personnel.
Do not operate with suspected failures.
Check body and cables regularly.
If any part is damaged, cease operation immediately and sequester the
instrument from inadvertent use.
SAFETY
Temperature
5 °C to 40 °C
Humidity
5% to 90% RH (non-condensing) up to 31 °C
decreasing linearly to 50% RH at 40 °C
Altitude
Up to 10,000 ft (3,048 m) at or below 30 °C
AC Power
100-240 VAC (±10%) at 50/60 Hz (±10%) or
100-120 VAC (±10%) at 400 Hz (±5%)
Automatic AC Voltage Selection
Consumption
Nominal
400 W / 400 VA
Maximum* 525 W / 525 VA
Standby
10 W