WaveAce Remote Control
WAVEFORM TRANSFER – WAVEFORM SETUP, WFSU
The WAVEFORM_SETUP command specifies the amount of data in a waveform to be transmitted to
the controller. This is defined by the parameters: Sparsing, interval between data points; Number of
Points, total number of points to be transmitted; First Point, the address of the first data point to be
sent; Segment Number, which segment to be sent if the waveform was acquired in sequence mode.
The WAVEFORM_SETUP? query returns the transfer parameters currently in use.
Command Syntax
WaveForm_SetUp SP,<sparsing>,NP,<number of transferred points>,FP,<first
point>,SN,<segment number>
<sparsing>:= 0 to
n
where 0 sends all data points
n
sends every
n
th data point
<number of transferred points>:= 0 to
n
where 0 sends all data points
n
sends a maximum of
n
data points.
<first points>:= 0 to
n
where 0 sends the first data point
n
sends
n
+1.
<segment number>:= 0 to
n
where 0 sends all segments
n
sends the
n
th segment.
NOTE: After power-on, all values are set to 0 (i.e., entire waveforms will be transmitted without sparsing).
Query Syntax
WaveForm_SetUp?
Response Format
WaveForm_SetUp SP,<sparsing>,NP,<number>,FP,<point>,SN,<segment>
Example
The following command specifies that every 3rd data point (SP=3) starting at address 200 (FP=200) in segment
23 (SN=23) should be transferred:
WFSU SP,3,FP,200,SN,23
Related Commands
WAVEFORM
68
920836 Rev B
Summary of Contents for WaveAce 1000
Page 1: ...WaveAce 1000 2000 Remote Control Command Reference...
Page 92: ......