Operator's Manual
SAVE/RECALL SETUP - *RCL
The *RCL command sets the state of your instrument, using one of the six non-volatile panel setups
(Panel 1 to Panel 6), by recalling the complete front panel setup of the oscilloscope. Entering panel
setup 0 corresponds to the default panel setup.
The *RCL command produces an effect the opposite of the *SAV command.
If the desired panel setup is not acceptable, the EXecution error status Register (EXR) is set and the EXE
bit of the standard Event Status Register (ESR) is set.
Command Syntax
*RCL <panel_setup>
<panel_setup>:= 0 to 6
Example
The following instruction recalls your instrument setup previously stored in panel setup 3:
*RCL 3
Related Commands
*SAV, EXR?
SAVE/RECALL SETUP - *RST
The *RST command initiates a device reset. *RST sets all eight traces to the GND line and recalls the
default setup.
Command Syntax
*RST
Related Commands
*CAL?
920836 Rev B
55
Summary of Contents for WaveAce 1000
Page 1: ...WaveAce 1000 2000 Remote Control Command Reference...
Page 92: ......