Teledyne Lecroy CP031, Operator'S Manual

Page: 8 / 28

CP03x/CP03xA Current Probes
test before connecting or disconnecting the probe. Avoid damaging cables through
excessive bending.
Never install or remove the probe on bare conductors which are energized . The
transformer core and shield are grounded but not insulated and may contact the
conductor when the locking lever is open.
Use the probe only with conductors carrying 300 V or less to avoid short circuits and
accidents that could result in injury or death.
Be sure the conductors measured are insulated with material conforming to
Overvoltage Category I (basic insulation requirement for working voltage of 300 V),
Pollution Degree 2 to prevent short circuits and electric shock when conductors carry
less than 300 V but more than the safe voltage level (SELV limit).
Be careful not to damage the insulation surface when making measurements.
Use only within the operational environment listed. Do not use in wet or explosive
atmospheres.
Do not remove the probe's casing . Touching exposed connections may result in electric
shock.
Keep product surfaces clean and dry .
Do not operate with suspected failures . Before each use, inspect the probe and
accessories for any damage such as tears or other defects in the probe body, cable
jacket, accessories, etc. If any part is damaged, cease operation immediately and
sequester the probe from inadvertent use.
2
www. .com
information@itm.com 1.800.561.8187