Operator’s Manual
Safety Instructions
Follow these instructions to keep this oscilloscope accessory operating in a correct
and safe condition. Observe generally accepted safety procedures in addition to the
precautions specified in this section.
The overall safety of any system incorporating
this accessory is the responsibility of the assembler of the system.
Symbols
These symbols appear on the probe body or in documentation to alert you to important
safety considerations.
HIGH VOLTAGE WARNING.
Risk of electric shock.
CAUTION
of damage to probe or instrument, or
WARNING
of hazard to health.
Attend to the accompanying information to protect against personal injury or
damage. Do not proceed until conditions are fully understood and met.
DOUBLE INSULATION
PROTECTIVE (EARTH) TERMINAL
Precautions
Avoid personal injury or damage to your equipment by complying with the following
safety precautions:
Use only as specified
. The probe is intended to be used only with compatible Teledyne
LeCroy instruments. Use of the probe and/or the equipment it is connected to in a
manner other than specified may impair the protection mechanisms.
Do not overload; observe all ratings.
To avoid electric shock or fire, do not connect
the current probe to any wire that carries voltages or currents that exceed the ratings
of the probe. Observe all terminal ratings.
Connect and disconnect properly
. Connect the probe to the measurement instrument
before connecting it to the circuit/signal being tested. De-energize the circuit under
1
www.
.com
1.800.561.8187
Summary of Contents for CP031
