23
Input/Output:
Specify current adding rule is input rule or output rule.
Deny/Permit:
Specify current adding rule is deny rule or permit rule.
Protocol Type:
Protocol using in this rule: TCP/IP/ICMP/UDP.
Port Range:
Port range of this rule.
Src Addr:
Source address. It can be a specific IP address or network address.
Dest Addr:
Destination address. It can be a specific IP address or network
address.
Src Mask:
Source address mask. Indicate the source is dedicate IP if set to
255.255.255.255. Otherwise is network ID.
Des Mask:
Destination address mask. Indicate the source is dedicate IP if set to
255.255.255.255. Otherwise is network ID.
3.5.6 VLAN Configuration
Below is QoS Configuration page:
E103-IP phone implement QoS based on 802.1p, The QoS is used to mark the
network communication priority in the data link/MAC sub-layer. E103-IP will sort the
packets using the QoS and sends it to the destination.
VLAN Enable
: Enable VLAN election, it can separate the voice message,
signaling message and data message at the second floor, and by configuring the IP
precedence which in ToS field of voice message to realize the separation of voice
message and data message at the third floor, through which to allow the upper
switch or router to forward the voice message firstly. (On condition that the switch
or router can identify the ToS field).
VLAN ID:
Dispose VLAN ID is added a Tag header after realize enable the VLAN
function. The realized voice packets transfer at the same VLAN. The prerequisite is
it must the same as VLAN of upper switch. The value range are 1~4094.
DiffServ Enable:
If enable the VLAN service, it indicates use DSCP mode to
realize three layers QoS. This moment, the DSCP of SIP signals which between
E103-IP Phone and MGC. It will use Class Selector 5 (The value is 0xA0). And the
DSCP of mediums information (In RTP packets) would be used the values of DiffServ
Value field.
DiffServ Value:
The value range
：
