15
----Set E103-IP
’
s IP address in the
IP Address
;
----Set netmask in the
Netmask
field;
----Set router IP address in the
Gateway
;
----DNS Domain:
----Set local DNS server in the
Preferred DNS
and the
Alternate DNS
。
Configure to dynamic obtain IP
----Enable
DHCP
;
If there is DHCP server in your local network, E103IP will automatically obtain
WAN port network information from your DHCP server.
Configure PPPoE:
----Enable
PPPoE
----
PPPoE server
: Enter
“
ANY
”
if no specified from your ITSP.
----Enter PPPoE username and password in the
username
and
password
.
E103IP will automatically obtain WAN port network information from your ITSP
if PPPoE setting and the setup are correct.
Notice
: If user accesses the IP phone through WAN port. She/he should use the
new IP address to access the IP phone when the WAN port address was
changed.
3.3.2 LAN Config
LAN IP /Netmask:
Set the IP and Netmask for the LAN
DHCP Server:
Enable DHCP service in LAN port; after user changed LAN IP,
phone will automatically modify DHCP Lease Table and save the configure
according to IP and Netmask, DHCP server configure won
’
t take effect unless you
reboot the device.
NAT:
Enable NAT.
Bridge Mode:
Enable this option to switch to bridge mode. IP phone won
’
t
assign IP for its LAN port in bridge mode and its LAN and WAN port will be in the
same network. (
This setting won
’
t take effect unless you save the config and
reboot the device
)
