CellFax Plus Installation and User Manual
7
2.3 Hardware Installation Steps
1. Unscrew the screw from the SIM cover on the underside of the Cellfax Plus and remove
the SIM cover.
2. Slide the SIM latch open and insert a SIM card making sure the gold contacts of the
SIM touch the gold contacts of the SIM holder.
3. If your Cellfax Plus unit was supplied with a Battery, then push the 3 pin male
connector found on the Battery into the female connector found in the housing of the
SIM holder, making sure you line up the connectors correctly.
4. Place the Battery in the space allocated and then reattach the SIM cover. Replace the
screw.
5. Connect a regular telephone into the socket marked ‘Phone’ indicated on Cellfax
Plus back panel.
6. Connect a Fax machine into the socket marked ‘Fax’ indicated on Cellfax Plus back
panel.
7.
(optional)
Connect a landline to the socket marked ‘PSTN” on Cellfax Plus back panel.
Caution:
Do NOT plug a landline into the “Phone socket” as this may cause damage.
8. Connect the antenna to the socket marked “Y” on Cellfax Plus back panel.
9. Plug one end of the power adapter into the power socket and the other end into the
“12VDC” power interface indicated on the back panel.
To turn the CellFax Plus ON:
Press the power button to turn on. The LEDs
,
, , and
(
if fitted
)
will come on for approximately 6 seconds then go out leaving the
Status indicator flashing while initialising. Once the Status indicator and GSM signal
status LEDs are lit the device is ready to use.
NOTE:
If the GSM signal LEDs start to flash then refer to GSM errors above.
NOTE:
If batteries are fitted then Charging Times are: 12 hours for the first time,
8 hours thereafter.
To turn the CellFax Plus OFF:
Press and hold the power button for 3 seconds; release
the power button, the Power and Network indicators turn off immediately.
