Telecom Behnke myintercom Plus, Instructions Manual, Page: 61 / 84

61 www.behnke-online.de
myintercom Plus IP video door intercom Instructions
Card reader
GB
4.2. Transponder
Programming the transponder
Attention:
When programming the transponder, ensure
that an already allocated memory location is
not overwritten with a new number, because
the transponder whose number is overwritten
loses its authorisation as a result.
Hold the master card in front of the card
reader and select the required memory loca-
tion (see “4.1. Selecting the memory location“
on page 61). Hold the new transponder
in front of the card reader, while the display
flashes. The transponder is programmed with
the selected memory location and the right-
hand decimal point lights up.
Note: If an already saved transponder is held
in front of the card reader, the display jumps
to its memory location.
You can now remove the transponder. The dis-
play jumps automatically to the next memory
location. To end the write operation, remove
the master card, the display goes out and the
card reader switches to operating mode.
4.1. Selecting the memory location
Hold the master card in front of the card
reader. The display switches itself on:
The memory locations are displayed from 0 to
10 in steps of 1. (
00...01...02...03...
)
From the 10th memory location the counting
continues in steps of 10s (fast mode).
To count in steps of 1 again, remove the
master card briefly and then hold it in front
of the card reader again. The next 10 memory
locations are now counted in single steps
again, then fast mode starts again.
To select a memory location, remove the
master card. The display lights up continu-
ously for approx. 3 seconds and then flashes
for approx. 6 seconds. The memory location
can now be programmed or deleted.