TeleAlarm TA74, User Manual

Page: 34 / 60

34 en | Programming TA74 User Manual
© TeleAlarm SA TA74_UM_EN_V2.5_2019.09_Final
6.3.4 Entering Service mode
1. Press the Maintenance button for about 6 seconds to enter Service mode.
► The device beeps and the blue LED flashes until the preset time expires or the Action
button is pressed.
2. Press the Action button once. The device outputs announcement <1>.
Press the Action button again. The device outputs announcement <2>.
Press the Action button again. The device outputs announcement <3>.
Press the Action button again. The device outputs announcement <4>.
Press the Action button again. The device outputs announcement <5>.
Press the Action button again. The device outputs announcement <6>.
► If the Action button is pressed again, a new cycle begins and the device outputs
announcement <1>, etc.
3. When the desired number is announced, press the Emergency call button to access
the related function. Functions 3 and 6 play their current status automatically after
two seconds.
Service mode functions:
INFO
It is only possible to enter Service mode when the device is on standby (no active
emergency call).
Function Description
Function 1 Register wireless transmitter 1.
See section
6.4, Page 35 .
Function 2 Register wireless transmitter 2.
See section
6.4, Page 35 .
Function 3 Set Dynamic Host Configuration Protocol (DHCP) mode
and announce IP address.
See section
6.5, Page 36 .
Function 4 Wireless transmitter range test.
See section
6.6, Page 37 .
Function 5 GSM signal level test.
See Section
6.7 , Page 38 .
Function 6 Call progress tones audible.
See Section
6.8 , Page 39 .
INFO
To use function 4, the wireless transmitter must already be registered in the TA74.