TA74 User Manual
Programming | en 37
TA74_UM_EN_V2.5_2019.09_Final
© TeleAlarm SA
6.6
Wireless transmitter range test
It is possible to switch the TA74 to test mode in order to test the radio range of the wireless
transmitter. If you press the wireless transmitter button, the TA74 emits an acoustic signal
without initiating an emergency call.
Calling up and using the wireless transmitter range test
1. Press the
Maintenance button
and use function 4.
► If necessary, see section
6.3.4 "Entering Service mode", page 34
► When you access the wireless transmitter range test, a 3-minute timer starts. The device
will automatically terminate the wireless transmitter range test at the end of the 3 minutes.
► The red indicator lamp flashes every 2 seconds and the TA74 emits a short beep every
5 seconds to indicate that test mode is enabled.
2. Press the button on the wireless transmitter.
► When the TA74 receives the signal from a registered wireless transmitter, it emits a
long acoustic signal.
3. Press any button on the TA74 to exit the test mode.
INFO
In order to test the wireless transmitter range, it must first be registered in the TA74.
INFO
If no acoustic signals are emitted by the TA74 when the wireless transmitter button is pressed,
it means that the transmitter is out of range or something is blocking the transmission.
INFO
Every time the TA74 receives a signal from a registered wireless transmitter, the 3-minute
timer will be reset.
If no signal is received during 3 minutes, the TA74 will automatically return to standby mode.
